Table of Contents
Advertisement
To reposition the wedge adaptor:
Engage the centre lock (see
Hold the body of the wedge adaptor
securing screws (15).
Reposition the wedge adaptor
of the wedge adaptor faces forwards
Insert the four screws
Platform slide clamp adjustment
The platform slide clamp should be set so that, in the up or clamped position it prevents the plat-
form slide from being moved, while in the down or released position it allows free adjustment of
the slide. To adjust the clamp, proceed as follows:
Pull the slide clamp lever
Slacken the clamp screw (14.2).
Turn the slotted shaft
Tighten the clamp screw (14.2).
Move the lever over its full range and ensure that, in the clamped position, it prevents the
slide from being moved, while in the released position it allows free adjustment of the slide.
Re-adjust if necessary.
(14)
(14.2)
Brake and drag control knob adjustment
The pan and tilt brake and drag controls may require adjustment after prolonged use. These ad-
justments should be carried out by competent persons as detailed in the Maintenance Manual.
The Maintenance Manual may be obtained from Vinten Broadcast Limited or your local Vinten dis-
tributor or from our website at www.vinten.com.
Locking the
(14)
(14)
on the sliding plate (13), ensuring that the narrow end
(15)
in the holes in the wedge adaptor and tighten.
(14)
fully upwards.
(14.1)
fully clockwise to apply the clamp.
Fig 5 Platform Side Clamp Adjustment
platform) and remove the payload.
and use a 4 mm hexagon wrench to remove four
Back
(14.1)
20
Advertisement
Table of Contents
