Pan And Tilt Brake Adjustment - Vinten Vector 700H Operator's Manual

Pan and tilt brake adjustment

The pan and tilt brakes should be set so that the brakes begin to be applied after approximately
one-third of the lever travel.
The tilt brake is adjusted by inserting a 2 mm hexagon wrench through the hole
of the tilt unit cover and turning the grub screw (5.1). To adjust the tilt brake, proceed as follows:
Operate the tilt brake lever
If brake pressure is not felt after approximately one-third of the lever travel, turn the grub
screw (5.1) clockwise until this is achieved.
Operate the tilt brake lever
move.
(5)
(4)
(4.1)
(5) from the OFF to the ON position.
(5) to the OFF position and ensure that the platform is free to
2/3
1/3
Pan and tilt brake adjustment
(5.2) in the bottom
(5.1)
(5.2)
(29)
(30)
19