Pan And Tilt Brake Adjustment - Vinten Vector 750 Operator's Manual

WARNING! Overlong screws will prevent the slide plate from operating.
To reposition the wedge adaptor:
Engage the centre lock (see
Hold the body of the wedge adaptor
securing screws (3).
Reposition the wedge adaptor
the wedge adaptor faces forwards.
Insert the four screws

Pan and tilt brake adjustment

The pan and tilt brakes should be set so that the brakes begin to be applied after approximately
one-third of the lever travel.
The tilt brake is adjusted by inserting a 2 mm hexagon wrench through the hole
of the tilt unit cover and turning the grub screw (5.1). To adjust the tilt brake, proceed as follows:
Operate the tilt brake lever
If brake pressure is not felt after approximately one-third of the lever travel, turn the grub
screw (5.1) clockwise until this is achieved.
Operate the tilt brake lever
move.
(5)
(4)
(4.3)
Always use the screws provided (M6 x 30 mm).
Locking the
(1)
(1) on the slide plate (14), ensuring that the narrow end of
(3) in the holes in the wedge adaptor and tighten.
(5) from the OFF to the ON position.
(5) to the OFF position and ensure that the platform is free to
2/3
1/3
Fig 10 Pan and tilt brake adjustment
platform) and remove the load.
and use a 4 mm hexagon wrench to remove four
Back
(5.2) in the bottom
(5.1)
(5.2)
(4.1)
(4.2)
23