XYZ Printing da Vinci Color mini User Manual page 12

Function Operation and Instructions
C2-1 Ink Calibration
We suggest you print a test page after you install the ink cartridge. Please prepare a sheet of paper.
1. Tap Calibration.
3. Take out the EZ Removable
Rubber Magnet. Use tape to
secure the A4 in the portrait
direction on the front side of the
rubber magnet.
6. Put the rubber magnet back
to print bed accordingly.
Test Page print examination
Picture 1 shows an example
of normal test page.
Test Page
2. Tap Test Page.
4. Tighten/pull the A4 paper so
it is flat(no gap) on the rubber
magnet.
7. Fix the paper onto the print
bed and then tap PROCEED,
the printer will do a test print.
Picture 2 show some
slight color offset on
horizontal part of test
page.
It is under accep-
tance range. If the
rprint of the test page
gets worst, please
proceed with the
cleaning procedure.
5. Fold tightly the excess A4 paper to the back of the rubber
magnet.
8. Remove the test page and
tap PROCEED.
Picture 2-1 shown
some slighly black
ink smudge on the
horizontal & vertical
part, it may happen
to other color. This
is within accaptable
range.
da Vinci Color mini
P12