Download Print this page

XYZ Printing da Vinci 1.0A Quick Manual

Hide thumbs Also See for da Vinci 1.0A:

Advertisement

Quick Links

WARNING: This 3D Printer - when used with a styrene filament (ABS /
HIPS / or PC-ABS) can expose you to chemicals, including Styrene, which
is known to the State of California to cause cancer. For more information,
visit www.p65warnings.ca.gov
Product Manual
Advanced Maintenance Tools
Print Bed Adjustment
Service Code Informations
da Vinci 1.0A
ENG
P.2-P.4
P.5
P.6
P.7

Advertisement

loading
Need help?

Need help?

Do you have a question about the da Vinci 1.0A and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for XYZ Printing da Vinci 1.0A

  • Page 1 Vinci 1.0A Product Manual P.2-P.4 Advanced Maintenance Tools Print Bed Adjustment Service Code Informations WARNING: This 3D Printer - when used with a styrene filament (ABS / HIPS / or PC-ABS) can expose you to chemicals, including Styrene, which is known to the State of California to cause cancer.
  • Page 2: Product Manual

    Overview fixers This guide provides details on how to start off your da Vinci 1.0A 3D printer correctly. Before you can begin printing, there are some easy procedures you need to become familiar with: ● How to open the box safely ●...
  • Page 3: Open The Box

    Product Manual Note: Cable tie illustrated in step 4 in this section is used to fix the extruder during transportation. Open the box It should be removed before powering on the printer, or the printer may not funtion normally. Tapex2 Packing support x2 Cable tie x1 Take out the printer...
  • Page 4: Sample Print

    Product Manual Load filament DA VINCI 1.0a uTILITIES CHANGE CARTRIDGE LOAD FILAMENT UTILITIES CHANGE carT UNLOAD FILAMENT SETTINGS HOME AXES JOG MODE INFO Choose"UTILITIES" Choose "CHANGE CART" Choose "LOAD FILAMENT" and press"OK" to and press "OK". and press "OK". continue.
  • Page 5: Maintenance Tools

    Copper brush is used to clean and remove molten filament left on the tip or surface of the extruder and inside the drive gear. When the printer fails to calibrate consistently; clean and remove the filament from extruder(s) surface. Specifications FEATURES da Vinci 1.0A 3D Printer FEATURES da Vinci 1.0A 3D Printer Print Technology Fused Filament Fabrication(FFF) Nozzle Diameter 0.4 mm...
  • Page 6 Step-by-step adjustment latest. I. Adjust the screw at Point A to reduce the difference between the 1st and the 2nd measurements. DA VINCI 1.0A II. Adjust the screw at Point B based on your evaluation of the UTILITIES SETTINGS INFO results obtained from the previous steps.
  • Page 7 Service Code Informations For further information and instruction of the service code, please refer to XYZprinting website (http://support.xyzprinting.com/global_en/Support) or contact service center for help. Display Panel Description Service Code 0 0 1 0 Extruder or print bed higher/lower than maximum/minimum temperature during printing Extruder or print bed cannot heat to the specified temperature 0 0 1 1 The temperature of print bed reach to warning range limited...