Connecting Power And Controls; Figure 2-10 Secure The Plug Plate And Gasket To The Side Egress - Will Burt PositionIt PI-35 Operator's Manual

I PI-35
OSITION T
P
10. Secure plug plate and its gasket at the side egress where the removable plug had
previously been installed from the factory (Figure 2-10). Apply silicone sealant or
equivalent to the screws. If the gasket is not properly installed, the positioner will leak
and become damaged voiding the warranty.

Figure 2-10 Secure the Plug Plate and Gasket to the Side Egress

11. Check to ensure both plug locations are properly sealed. If either plug location is not
properly sealed, the positioner will leak and become damaged voiding the warranty.

2.6.2 Connecting Power and Controls

This section describes how to connect the power and controls to the system.
Equipment Damage! Ensure the connections are made properly to prevent water ingress into
the positioner through the connections. Should water enter the positioner, extreme problems
can occur.
Depending on the configuration of your system, power and controls can be hooked up several
different ways. Select the appropriate method for your system and wire accordingly:

Powered with 12 VDC

Powered with 24 VDC

Powered with 120 VAC (50 or 60 Hz) or 240 VAC (50 or 60 Hz)
2-8 TP-5406201-B
July 2017