I
PI-35
OSITION
T
P
5.2.3 Protocol
When the controller is powered on, the protocol will be displayed. The protocol should be Pelco
D. If necessary, reset the protocol to Pelco D. A quick guide to resetting the protocol can be
found in Table 5-3.
1. Keyboard setup
2. Dome setup
3. Protocol select
4. Exit menu
To reset the protocol:
1. Press [Menu] for (2) seconds. The Menu screen will appear (Figure 5-2).
2. Navigate to <Protocol setup> and move the joystick to the right to go to the submenu.
The Protocol setup screen will appear (Figure 5-3).
3. Navigate to <Dome> and move the joystick to the right to go to the submenu. The Dome
screen will appear (Figure 5-4).
4. Navigate to <Pelco-d> and move the joystick to the right to select Pelco D as the
protocol. <Success!> will briefly flash at the bottom of the LCD screen and the display
will return to the Protocol setup screen (Figure 5-3). The setting is saved.
5-4
Table 5-3 Resetting the Protocol
1. Quad/DVR
2. Dome
1. Keyboard setup
2. Dome setup
3. Protocol setup
4. Exit menu
Figure 5-2 Menu Screen
1. Quad/DVR
2. Dome
Figure 5-3 Protocol Setup Screen
1. Factory
2. Pelco-p
3. Pelco-d
4. DH-SD
Figure 5-4 Dome Screen
1. Factory
2. Pelco-p
3. Pelco-d
4. DH-SD
TP-5406201-B
July 2017