Figure 1-3 Positioner; Figure 2-11 Powered With 12 Vdc - Will Burt PositionIt PI-35 Operator's Manual

Powered with 12 VDC:
The positioner runs on 24 VDC and power other than 24 VDC must be converted to 24 VDC for
the positioner.
If the input power supply is 12 VDC, the system will require:

A step up converter (P/N: 208012) from 12 VDC to 24 VDC to power the positioner

A connector (P/N: 5195601) to connect 12 VDC to the controller
Figure 2-11 provides a quick overview of the wiring for a system powered with 12 VDC input.
12 VDC
Power
5 Amp Fuse
Supply
Barrel Connector
(P/N: 5195601)
To wire the positioner using 12 VDC:
1. Reference WD-50610, page 1 of 3 in Section 7.
2. Connect the 5-pin plug (attached to the power/data cable) to the positioner.
3. Twist the plug to the right to secure the connection.
4. Run the 22 AWG green (data A, +) and white (data B, -) wires from the power/data cable
to the controller.
5. Run the 16 AWG red (power) and black (ground) wires from the power/data cable to the
step up converter.
6. Run the 12 VDC power to the controller and the step up converter. Run a (5) amp slow
blow fuse (customer supplied) inline between the power supply and the controller and
step up converter. An optional DC cable connector may be used to connect the
controller and the power supply.
TP-5406201-B
July 2017
Step Up
Converter
(P/N: 208012)
Power
Wires
(Optional) Default Joystick
Controller
(P/N: 5098901)

Figure 2-11 Powered with 12 VDC

I PI-35
OSITION T
P
Power
Wires
Positioner
Control
Wires
2-9