Dust Chute Assembly - Oliver 4650 Owner's Manual

Fence Assembly
1. Disconnect machine from power source.
2. Install rail brackets (A, Figure 1) to the table
as shown using the supplied hardware. See
inset B and notice the elongated hole of the
bracket mates with the edge of the table Do
not fully tighten at this time.
Figure 1
3. Loosely install the supplied carriage bolts
and nuts onto the rail brackets as shown in
inset B of Figure 2. Line up the two large
holes in the rail with the two carriage bolt, as
shown in Figure 2. Slide the rail to the right
and tighten into place.
Figure 2
4. Place the fence on the rail as shown in
Figure 3. Use the slotted holes in the rail
brackets to raise or lower the front end of
the fence so it closely matches the height of
the rear end of the fence.
place.
5. To fix the measuring tape to the rail, move
6. The measuring tape is peel and stick but at
7. Mark the position of the tape on the rail. As
8. Remove the backing and fix the tape to the
Tighten into
9. Repeat for the right side.
7
Figure 3
the fence into position so that it is just
touching the blade as seen in Figure 3.
Note that the fence has two position
indicators. Cut the tape in the middle
between the two zero's.
this time just slide the left tape under the
fence bracket on the rail so the zero mark on
the tape lines up with the left indicator on the
fence as shown in Figure 4.
Figure 4
well, make sure the tape is centered
between the V's of the fence to prevent the
fence rubbing on the tape.
rail.