Table of Contents
Advertisement
Electrical Connections
WARNING
Electrical connections and wiring must be
done by a qualified electrician. The machine
must be properly grounded. Failure to
comply may cause serious injury!
The bandsaw is available in both 1-Phase and
3-Phase versions.
Electrical Connections for a 3-Phase Unit
This bandsaw is 3-Phase, 220V.
Machinery recommends using a dedicated
circuit.
Make sure the voltage of your power supply
matches the specifications on the motor plate of
the machine.
1. Disconnect machine from power source!
2. Remove nuts that secure the cover to the
connection box.
3. Insert the power cable through strain relief,
and attach the wires to the terminals.
4. Re-install the connection box cover. With
3Ph power verify the blade is turning in the
proper direction. Turn the bandsaw on and
make sure the blade travels in a clockwise
direction when viewed from the front. If it
does not, disconnect the machine from
power source and reverse any two incoming
power leads.
5. When wiring is completed, tape all power
box joints to keep out dust.
Electrical Connections for a 1-Phase Unit
This bandsaw is 1-Phase, 220V only.
Machinery recommends using a dedicated
circuit.
Make sure the voltage of your power supply
matches the specifications on the motor plate of
the machine.
1. Disconnect machine from power source!
2. Remove nuts that secure the cover to the
connection box.
Oliver
3. Insert the power cable through strain relief,
and attach the wires to the terminals.
4. Re-install the connection box cover.
5. When wiring is completed, tape all power
box joints to keep out dust.
Dust Collection
There are two 4" dust port located on the back of
the machine cabinet. Make sure dust collection
system has sufficient capacity and suction for
your bandsaw. Always turn on dust collection
system before starting the bandsaw.
Brake Pedal
Press the brake pedal while the saw is running
to stop the saw. Re-start the saw by pressing
the on switch.
12
Oliver
Advertisement
Table of Contents
