Table of Contents
Advertisement
Contents of the Shipping Containers
Picture 2
1. Fence
2. Rail
3. Miter guage
4. Rail brackets
5. Speed handle
6. Wrenches
7. Allen keys
8. Rail mounting hardware
9. Measuring tape for rail
10. Eye bolts
11. Tray
Uncrating the Machine
Your bandsaw should arrive crated as shown in
Picture 1. Inspect the unit for signs of shipping
damage.
If damage is found, contact the
delivering freight carrier immediately. Retain all
packaging
materials
necessary to ship the machine back to the
dealer or to another site.
Machine Preparation and Setup
WARNING
The equipment used to lift this machine must
have a rated capacity at, or above the weight
of the bandsaw. Failure to comply may
cause serious injury!
The bandsaw is bolted to the skid with four bolts.
Remove the bolts.
Screw the eyebolts (#10,
Picture 2) into the top of the machine and use a
forklift or similar to lift the bandsaw off the skid
and into position.
positioned on a smooth, level surface. The area
must be well lit and have plenty of room to
maneuver with large pieces of wood.
Level the saw front to back and side to side
using a level placed on the table. Use shims
under the corners, if necessary, but make sure
the saw is stable before being placed into
service.
Clean all rust protected surfaces with a
commercial solvent.
gasoline, lacquer thinner or any type of
flammable solvent, or a cleaner that may
damage paint.
Cover cleaned surfaces with
WD-40 or a 20W machine oil.
in
case
it
becomes
The bandsaw must be
Do not use acetone,
6
Picture 1
Picture 2
Advertisement
Table of Contents
