Oliver 4650 Owner's Manual page 11

Squaring Table to the Blade
1. Disconnect machine from power source.
2. Blade tension, tracking and guide setup
must be properly adjusted prior to squaring
the table to the blade, see "Tensioning
Blade" page 8, "Blade Tracking" page 9,
"Adjusting Upper Blade Guides" page 9 and
"Adjusting Lower Blade Guides" page 10.
3. Place a square (A, Figure 11) on the table
against the blade to see if the table is 90
degrees to the blade.
4. If adjustment is necessary loosen lever (B,
Figure 11) and tale stabilizing knob (B,
Figure11) and tilt table until it is square to
the blade. Re-tighten the lever and knob.
5. Adjust pointer (D, Figure 11) to read zero.
6. Check to see that the table is still square to
blade and make any additional adjustments.
7. If necessary loosen screw (K, Figure 9) and
adjust pointer to read zero.
Figure 11
11