Start-Up; A) Laying The Receiver Aerial Cable; B) Attaching The Telescopic Aerial To The Transmitter; C) Inserting Batteries/Rechargeable Batteries Into The Transmitter - Reely ROAD C-4ZG Operating Instructions Manual



8. Start-Up

a) Installing the Receiver Aerial Cable
For 27/40 MHz remote controls, the receiver's aerial cable is normally rolled up on delivery. Unwrap the aerial cable
completely and smoothen it carefully. For this, hold the aerial cable near the receiver with two fingers (do not hold the
receiver but the cable) and then pull the cable straight with two fingers of your other hand (repeatedly if necessary).
Then insert the aerial cable through the attachment from below (possibly already performed by the manufacturer).
Guide it through the aerial tube and plug the aerial tube into the respective attachment mount on the vehicle. Simply let
excess aerial cable protrude loosely from the tip of the aerial tube.
If a rubber cap for the aerial tube is enclosed; it prevents the dislocation of the aerial cable after it is attached to the tip.
Make sure that the aerial cable does not protrude into the drive or touch the cardan shaft! It is normally
sufficient to slightly tighten the cable or fix it in place with a cable binder.
Never shorten the aerial cable! Never roll up the aerial cable! This greatly reduces the range!
b) Attaching the Telescopic Aerial on the Transmitter
For 27/40MHz remote control systems, the transmitter has a telescopic aerial. If it is included separately (and not
already screwed into the transmitter), insert it into the corresponding opening on the transmitter from above and screw
it tight by hand. Do not use any force when screwing the aerial in; do not use any tools!
c) Inserting Batteries (or Rechargeable Batteries) in the Transmitter
Open the transmitter's battery compartment and insert either batteries or fully charged rechargeable batteries. Ob-
serve correct polarity (plus/+ and minus/-), see label on the battery compartment. Close the battery compartment.
d) Switching on the Transmitter
In a 27-/40MHz remote control system, the telescope aerial first must be extended to its full length. Do not use any
force and do not bend the telescopic aerial!
Then switch on the transmitter.
Put the trimming for driving into the centre position. If the transmitter has a dual rate function, deactivate it. Observe the
operating instructions of your remote control system!
41