BART LABDMM2 User Manual page 42

LABDMM2
If the data logger option is enabled in the menu, the following configuration parameters are enabled.
t1
h.mm.ss
t2
hhh.mm
t On
t OFF
22. DISPLAY AND SETTING OF DATE AND TIME
hh.mm
+
P0000
d1
d2
d3
d4
d5
USER GUIDE
20. DATA LOGGER (Option)
21. DATA LOGGER PARAMETERS
Defines the time between 2 ACQUISITION INTERVALS.
You can set: h = hours, mm = minutes, ss = seconds
Example: 1.30.05 = 1 hour, 30 minutes and 5 seconds
Changing this parameter will reset the current log to zero.
Defines the global time of CYCLE DURATION.
You can set: hhh = hours, mm = minutes
Example: 024.30 = 24 hours and 30 minutes.
For times longer than 1000 hours the display format changes showing only the
hours allowing you to set t2 times up to 10000 hours
Enables / disables the storage of the TEMPERATURE.
By setting tOFF it is possible to record only the PRESSURE and memorize up to
130,000 measuring points.
By setting tOn it is possible to record both the PRESSURE and TEMPERATURE and
memorize up to 65,000 measuring points.
Display of current hour and minute, it's active only if Datalogger option is
enabled.
Press the keys simultaneously for a few seconds SET and PEAK.
Set the password 8321 (
Allow to set the YEAR
Modify the parameter using the
Confirm with SET to go to the next parameter.
Allow to set the MONTH
Modify the parameter using the
Confirm with SET to go to the next parameter.
Allow to set the DAY
Modify the parameter using the
Confirm with SET to go to the next parameter.
Allow to set the HOUR
Modify the parameter using the
Confirm with SET to go to the next parameter.
Allow to set the MINUTE
Modify the parameter using the
Confirm with SET to finish setting the date and time.
 ) and confirm with SET.
 and  keys.
 and  keys.
 and  keys.
 and  keys.
 and  keys.
Pag. 14
MO.LABDMM2.560.ENG.R1