Table of Contents
Advertisement
Alarms and Maintenance
|
2 | Configure DSM Network
|----|------------------------------------|
|
3 | Configure Forwarded Ports
|----|------------------------------------|
|
4 | Configure Static NAT Addresses
|----|------------------------------------|
|
e | Exit
\-----------------------------------------/
Enter choice:
The following warning appears:
ELAP software is running. Stop it?
d) Type Y and press Enter.
If the LSMS Connection has not been previously disabled, the following prompt appears:
The LSMS Connection is currently enabled. Do you want to disable it? [Y]
e) Type Y and press Enter.
The following confirmation appears:
The LSMS Connection has been disabled.
The ELAP A provisioning network IP address displays:
Verifying connectivity with mate ...
Enter the ELAP A provisioning network IP Address [192.168.61.90]:
f) Press Enter after each address is displayed until the Default Route address displays:
Verifying connectivity with mate ...
Enter the ELAP A provisioning network IP Address [192.168.61.90]: Enter the ELAP
B provisioning network IP Address [192.168.61.91]: Enter the ELAP provisioning
network netmask [255.255.255.0]:
Enter the ELAP provisioning network default router IP Address: 192.168.61.250
g) If the default router IP address is incorrect, correct it, and press Enter.
h) After vverifying or correcting the Provisioning Network configuration information, enter e to
return to the Configure Network Interfaces Menu.
i) Enter e again to return to the ELAP Configuration Menu.
2. Rerun syscheck.
• If the alarm has not been cleared, contact
the syscheck output available to them. This procedure is complete.
• If the alarm has been cleared, the problem is solved, and you can restart the ELAP software and
enable the connection to the LSMS as described in
3. Perform the following substeps to restart the ELAP and enable the LSMS connection.
a) Restart the ELAP software (see
b) Select Maintenance>LSMS Connection>Change Allowed: a window similar to the example
Figure 26: Enable LSMS Connection Window
shown in
E76220 Revision 1, July 2016
1
Restarting the ELAP
Platform and Application Alarms
|
|
|
|
My Oracle Support (MOS)
Step
3.
Software).
displays.
Y
for further assistance. Make
83
Advertisement
Table of Contents
