Table of Contents
Advertisement
Alarms and Maintenance
Table 7: Usernames
ELAP UI Login Name
elapmaint
elapdebug
elapplatform
uiadmin
elapall
3. Continue with the procedure that invoked this procedure.
Connecting to the Server Command Line
You can connect to the ELAP server command line for the following purposes:
• Accessing the ELAP text interface (see
• Running syscheck (see
It is possible to connect to the ELAP server command line in any of the following ways:
• Use a secure shell (ssh) utility to connect to either server's IP address. This connection will be
made through the port that is identified as eth01 on the ELAP E5-APP-B Interconnect and is
identified as eth91 by the software. For more information, see
Command
Line.
• Use a secure shell (ssh) utility to accessible ELAP server. Use command minicom mate to log on
to the mate ELAP server's command line.
• If access to the MPS server is not available through an IP network, connect to the E5-APP-B card
via the serial port:
For connecting the E5-APP-B A card, disconnect the console cable from the serial port on the
E5-APP-B card's adapter. The cable should be disconnected at the point where it connects to the
serial port labeled 'S1' on the E5-APP-B card's adapter and use it for serial access. Cable part numbers
- 830-1220-xx.
• Connect a cable, Part Number 830-0058-xx (xx represents the cable length), to serial port ttyS0 on
either the A or B server (see
Using ssh to Connect to the Server Command Line
You can log into either ELAP server from any terminal using a ssh (Secure Shell) utility.
Note:
E76220 Revision 1, July 2016
Accessing the ELAP Text
Running the System Health
Connecting a Local Access Terminal to Server s Serial
Access Granted
Maintenance menu and all sub menus
Debug menu and all sub menus
Platform menu and all sub menus
User Administration menu
All of the menus in this Table
Interface)
Check)
Using ssh to Connect to the Server
General Procedures
Port).
109
Advertisement
Table of Contents
