Installation of the Coded Zoom in LAS X
Installation of the coded zoom knob in the
Leica Application Suite (LAS) Software X
1. Open
the
"Leica
LAS X
Configurator". Click on this link on your
desktop.
2. Please select "Hardware Setup".
S Series User Manual
3. Check the box to mark the "coded knob".
Hardware
Extend!
Calibration in LAS X (to lowest, highest, and
1× magnification)
1. To calibrate the coded knob click on
"Configure" on the upper, left side. Then
click on "Fine Tuning" in the right menu.
2. Manually set the zoom knob on the S9 to
lowest magnification.
3. Confirm the setting to lowest limit in the
software by clicking on "Go to lower Limit".
55