6. Assembly
6.2 Installation of the
Transmitted Light Illumination Carrier (DL)
Wipe the installation surface (8.3) with a dry
cloth. Tip the illumination carrier (8.1) back
slightly and install it so that the pin (8.2) engages
the groove in the support surface (8.4).
Set the DL illumination carrier upright and fasten
it with the 4 screws.
When fastening the transmitted light illumina-
tion carrier, do not hold it so as to ensure its op-
timal alignment with the optical axis.
The tilt angle of the illumination carrier can be
varied with the knurled screw (9.1) or fixed verti-
cally. Connect the electronics cable to one of
the sockets, EXT1 - EXT4.
26
The transmitted light lamp housing for 12V 100W
halogen lamps is a separate component. For in-
structions on replacing the halogen lamp
→ Ch. 6.10, p. 41.