Redial Count; Dp Make/Break; Silence Time; Error Rate - Ricoh FAX1120L Service Manual

TECH MODE

REDIAL COUNT

• You can set the number of times you want the machine to redial automatically;
when automatic transmission is done, when the remote machine is busy or when
the machine sends a fax. If there is no response after redialing the number of
times specified, redial is terminated. Enter the desired times from 0 through 2.
No redial will occur if the setting is 0.

DP MAKE/BREAK

• Select the dial pulse make and break time: 40/60 or 33/67.
CAUTION: This is set in the factory before shipment. These settings should never
be changed.

SILENCE TIME

• In ANS/FAX mode, after a call is picked up by the answering machine, the
machine monitors the line.
• If a period of silence is detected on the line at any time, the call will be treated as
a fax message and the machine begins receiving.
• Silence detection time is selectable between 12 seconds and unlimited time.
• When "12 sec" is selected, the machine switches to receiving mode as soon as it
detects a period of silence.
• When "Unlimited" is selected, the machine waits until the answering operation
has terminated. After the answering operation has terminated, the machine
switches to receiving mode.

ERROR RATE

• When the error rate is over the setting value, the Baud rate will automatically
lower by up to 2400 bps to make the error rate remain below the setting value.
• You can select the rate between 5% and 10%.

IGNORE TONER EMPTY

• You can set this function ON if you wish to drive the engine continuously. The
machine will continue to run regardless if the toner has run out, or toner empty
status is displayed.
5-4
10 October, 2002