Additional Hardware Components - OLIMEX STM32-H405 User Manual

OLIMEX© 2016 STM32-H405 user's manual

6.5 Additional hardware components

The hardware components below are mounted on STM32-H405 but are not discussed above. These
are listed here for completeness:
RESET button – used for hardware reset of the board; typically cannot be re-programmed;
connected to STM32F405's pin #7 (NRST)
BUT button – customizable button; can be re-programmed by the user – connected to
STM32F405's pin #14 (PA0); also available at pin #4 of the EXT2 header
PWR LED – indicates when the board is powered; cannot be re-programmed; it is not connected to
the main microcontroller
STAT LED – customizable LED; can be re-programmed by the user – connected to STM32F405's
pin #53 (PC12); also available at pin #10 of the EXT1 header; this LED can also be disabled if you
disconnect jumper LED_E; the jumper pads can also be used for measrements
Page 22 of 30