CommScope SYSTIMAX 360 iPatch 360G2-iP-32-MPO-SD-KIT-5PK Instruction Sheet page 9

www.commscope.com
Step 3c – Instructions Specific to Each Type of Fiber Shelf
SYSTIMAX 360G2 1U/2U Sliding Shelf
UD 2U/4U Sliding Modular Shelf
HD 1U/2U/4U Sliding Modular Cassette Shelf
SYSTIMAX 360G2 1U and 2U Fixed Shelves
SYSTIMAX 360G2 1U Internal Sliding Shelf
SYSTIMAX 360G2 4U Fixed Shelf
SYSTIMAX 360 1U/2U/4U Modular Shelf
SYSTIMAX 360G2 UHD 1U/2U/4U Modular Shelf
SYSTIMAX 360G2 1U/2U Sliding Shelf MPO Upgrade Kit Installation
1. From the front of the rack, slide shelf forward.
2. Remove front door by gently pressing both upper corners to release the latches. Then lift the door off the
trough.
3. Remove top cover by sliding toward front of shelf.
4. Refer to General Instructions, Steps 3a and 3b, for detailed installation procedure.
5. To replace the shelf's top cover, position between lower and upper sets of tabs on each side of shelf and slide
into place.
6. Slide shelf to stored position.
UD 2U/4U Sliding Modular Cassette Shelf
Shelf is not shown for clarity
1. Slide modular pair tray forward for access. Trays slide to the front of the shelf separately until reaching
stops that prevent them from sliding out.
Ribbon
cable
Modular pair tray
Distribution panel
(2 places)
Release latch
860543388
Instruction Sheet
iPatch
upgrade kit
860543388-008
Page 9 of 19