CommScope SYSTIMAX 360 iPatch 360G2-iP-32-MPO-SD-KIT-5PK Instruction Sheet page 14

860543388
Instruction Sheet
SYSTIMAX 360G2 4U Fixed Shelf MPO Upgrade Kit Installation
Rear door
Hinged panel
Door tabs
1. From the front of the rack, open front door.
2. See General Instructions, Step 3a, for detailed installation procedure.
3. From rear, open rear door and secure hinged panel to rear door using door's tabs.
4. Route ribbon cables through flat retainer clips and plug into backplane kit. Refer to cable routing table and
drawings as shown on the next page.
Note: Accessories (module slots) are labeled from front as columns A, B, C, and D.
Rows are labeled from top as 1, 2, 3, and 4.
Example: Ribbon cable from module 1 C-D plugs into backplane kit 2, connector C or D.
5. Remove protective cover to expose adhesive on backplane kit. Mount two backplane kits (one kit per 2
rows) to shelf floor at left rear corner as shown above.
6. Route both panel bus jumpers from the two backplane kits out to panel bus through side wall openings
as shown.
7. Release hinged panel and close rear door. Close front door.
Page 14 of 19
1
2
3
4
Backplane kit 1
C, D Module side
Connector 5
Connector 3
Panel bus
jumper
connector (Bus)
Connector 1
Feed two panel bus jumpers
Backplane kit 2
www.commscope.com
Backplane Kit
A, B Module side
Front
Connector 4
Connector 2
Front
Panel bus
860543388-013