CommScope SYSTIMAX 360 iPatch 360G2-iP-32-MPO-SD-KIT-5PK Instruction Sheet page 16

860543388
Instruction Sheet
SYSTIMAX 360G2 UHD 1U/2U/4U Modular Shelf MPO Upgrade Kit Installation
Cover
®
iPatch MPO
upgrade kit
LED kit
cable
Front
LED kit
Replace center fiber
patchcord divider with
front LED kit (Detail A).
1. From the front of the rack, pull
a sliding tray shelf forward.
2. Lift the patch cover.
3. Prepare to install MPO upgrade kit
by feeding black
through faceplate
between two MPO bezels.
4. Slide MPO upgrade kit over bezels.
Securely mount onto bezel's latches
by pushing on center and each side
of the upgrade kit until it snaps in
place.
5. Replace center fiber
divider with front LED kit as shown in
Detail A. Use a small flat-blade screwdriver to pry the divider out and snap the front kit in place. Place the
back of front kit (without LED) into tray slot first, then snap the front into place as shown. When placing
the LED kit into the center divider slot, insert back of kit into back notch and then gently snap the front
(with LED light) into place to avoid breaking the front tab on LED kit.
6. Slide the sliding tray to stored position.
7. Close the patch cover.
Page 16 of 19
ribbon cable
slot located
patchcord
iPatch ® MPO
upgrade kit
Place the back of
front kit into raised tray
Shelf front
slot first, then snap
the front into place
Detail A (rotated 180°)
www.commscope.com
860543388-015
Front LED kit
Tab at back of front
kit hooks under
raised slot in patch
cord trough
860543388-016