CommScope SYSTIMAX 360 iPatch 360G2-iP-32-MPO-SD-KIT-5PK Instruction Sheet page 7

www.commscope.com
Detail A rotated 90°
Panel bus
port (max.
of 5 panels
per bus port)
Panel bus
assembly
iPatch MPO
upgrade kit
iPatch MPO upgrade kit
6. Insert the panel bus jumper 10-pin connector into the nearest cable bus port on the panel bus as shown
in Detail A.
7. Install spare port built into jumper cordage into panel bus frame by turning it at an angle, inserting into
frame, and turning it back perpendicular to frame.
Note: The connector is keyed. The polarized tab on the jumper connector fits into the nearest port in the
panel bus.
IMPORTANT: Make sure that the jumper connector is fully seated in the connector on the panel bus.
8. Feed the loose end of panel bus jumper into the back of the shelf through small opening at end of panel
back, as shown in Detail B. Carefully route the jumper under any modules or fiber, leaving it loose to be
connected later.
Panel bus
Detail B
jumper
connector
Backplane kit
with hole facing
10-pin
front of shelf
connector
Spare bus port
(start a new chain
with every 6th panel)
Panel
bus
jumper
Cable retainer
Black
ribbon cable
Instruction Sheet
Feed panel
bus jumper
Flat
retainer clip
Black
ribbon cable
Corrugated
tubing
860543388
Page 7 of 19