Advertisement
User Manual
Control Options
Please note: many of the following settings & images are based on an example of 8 Inputs and 4
Outputs, however this will change to match your chosen configuration
Front Panel Control
The chassis' front panel can provide simple manual push button control. Please follow the steps below
for controlling via this method.
The LEDs will indicate the connected inputs or outputs.
1. Press the Left or Right push buttons to select the connected output device, and press enter to
select a connection. Once complete the corresponding LED of the output will blink slowly. When
an output is switched off the LED will display "—"
2. Press the Up or Down buttons to select the connected input channel. Press enter to confirm your
selection, once this has been confirmed the LED will stop blinking
IR Control
The included IR Extension cable can provide simple IR control over the entire installation. Please ensure
the IR eye is in clear line of sight of the included remote.
Each individual HDBaseT board can also be controlled and integrated into the users control systems via
IR by creating the Terminal block IR cable using the following instructions and Pin Out.
Web-Gui Control
The seamless modular matrix provides an intelligent Web-Gui for changing settings and control of the
installation. The Web-Gui software can be accessed via the Lindy website under Downloads.
To access the Web-Gui
1. Connect the matrix to a LAN switch or PC using a Cat.x cable to the LAN port of the chassis.
2. Type the following IP address into your web browser: 192.168.10.254
Please note: the LAN switch or PC must use the IP address within the same IP segment as the matrix
Please ensure the web browser being used is the latest version
3. Once the logic screen appears, please
choose
English.
address
192.168.10.254,
mask is 255.255.0.0, the default
password is admin.
4. The main Web-Gui screen should now
appear with 2 submenus: Matrix
Control & Admin Setting
The
default
IP
Subnet
English
Advertisement
