Advertisement
User Manual
Get IP
address
Command:
GET IPADDR [CR/LF]
Return:
XXX.XXX.XXX.XXX[CR/LF]
Parameter:
Description:
get ipaddr
Get
selected
Command:
target
GET VER target [CR/LF]
firmware
version
Return:
VER target prm[CR/LF]
Parameter:
※ target={all，mainboard, ledboard, card1，
card2.....card12}
※ prm = {...}// according to actual firmware
version
Description:
Get selected target firmware version
Set the
System
Command:
Code of the
SET IR_SYSCODE prm1[CR/LF]
remote
control
Return:
IR_SYSCODE prm1[CR/LF]
Parameter:
※ prm1 = {all, 00,4e};
// all --means support all the system codes of the
remote(0x00, 0x4e);
00 -- means only support the system cose is 00
4e -- means only support the system cose is 4e
Description:
Set IR system code
Syntax
Syntax
Syntax
Example
Command:
GET IPADDR [CR/LF]
Return:
XXX.XXX.XXX.XXX[CR/LF]
Description:
get ipaddr
Example
Command:
GET VER all [CR/LF]
Return:
VER mainboard 1.2[CR]
VER ledboard 1.3[CR]
VER card 1.4[CR/LF]
Description:
Get all module firmware version
Example
Command:
SET IR_SYSCODE 00[CR/LF]
Return:
IR_SYSCODE 00[CR/LF]
Description:
Set IR system code is 0x00.
English
Advertisement
