Download Print this page
Lindy HDMI 8x8 Matrix Switch 1.3c Manual

Lindy HDMI 8x8 Matrix Switch 1.3c Manual

Hdmi 8x8 matrix switch 1.3c

Advertisement

Quick Links

HDMI 8x8 Matrix
Switch 1.3c
Manual
English
LINDY No. 38047
www.lindy.com
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - Second Edition (November 2010)

Advertisement

loading

Summary of Contents for Lindy HDMI 8x8 Matrix Switch 1.3c

  • Page 1 HDMI 8x8 Matrix Switch 1.3c Manual English LINDY No. 38047 www.lindy.com © LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - Second Edition (November 2010)
  • Page 2: Operation Control

    1. Introduction Thank you for purchasing the LINDY HDMI 8x8 Matrix Switch 1.3c with remote control and RS232/USB support. This high performance switch offers you the maximum convenience in HDMI signal distribution when you have multiple HDMI sources and displays to connect together. Each of the eight HDMI inputs can be directed to any of the eight HDMI outputs, so your displays can show up to eight different sources at the same time.
  • Page 3: Remote Control

    Rear Panel AC power input: 100-240V RS-232 Communication port USB control port Main dip switches HDMI dip switches HDMI input ports HDMI output ports 4. Remote Control Power: Turn the unit on/off Source select: Only buttons 1 & 2 are used in this area.
  • Page 4 For USB control, set Pins 1, 2 & 3 to “off” and Pin 4 to “on” Firmware update mode can only be used via RS-232 with the PC set to COM1. a. Power off your LINDY 8x8 HDMI Matrix and connect your serial cable to the RS-232 port and serial port of your PC.
  • Page 5 HDMI Input HDMI Output mapping area mapping area Status indicator Scan: Press the “scan” button, select “scan”, then select the detected port and click OK Setting: Press the “setting” button then press the “get” button to read back the device ID. Press the “set” button to write the device ID...
  • Page 6: Command Set

    Linkage: Press the “linkage” button to read back all the status ID’s Open/Close: Press either the “open” or “close” button to open or close the COM port Mapping: Select All Output: Click on “Select All Output” then select the source on the main menu. This quickly sets all the outputs to the same source.
  • Page 7: Fcc Certification

    WEEE in leggi statali in varie misure. Fare riferimento alle leggi del proprio Stato quando si dispone di un apparecchio elettrico o elettronico. Per ulteriori dettagli fare riferimento alla direttiva WEEE sul riciclaggio del proprio Stato. LINDY No. 38047 www.lindy.com...

This manual is also suitable for:

38047