Enthermics Titan Series Operator's Manual page 48

T
ROUBLESHOOTING
Code Refers to
*EFAn Fan or Fan Sensor
Failure
Red iv fluid Red LED is
temperature illuminated within
status iv storage shelf
indicator
48
Action required
◾Check to make sure the fan sensor wires did not disconnect from the fan
or the control board.
◾If the error persists after checking the wires, replace the fan.
◾Set the power switch to the OFF position.
◾Remove any iv bags from inside the warmer.
◾Set the power switch to the ON position.
◾Visually check to see if red LED remains illuminated.
◾Contact service if error persists.
*
All non-critical codes can be cleared using the standby button. Critical errors (marked with a *) can
only be cleared by setting the power switch at the rear of the warmer to the OFF position and
allowing the warmer to cool.
B l an k e t W a rm e r Op er a to r ' s Ma n u al
▪
M N- 39 9 2 4 Rev 3 3/ 2 0
▪ ▪ ▪