Otto Bock 9010 Wrist Support Instructions For Use Manual page 10

► The initial fitting and application of the product must be carried out by
qualified personnel.
► Instruct the patient in the handling and care of the product.
► Instruct the patient to see a physician immediately if any exceptional
changes are noted (e.g. worsening of the complaint).
4.1 Selecting the Size
The support is available in a universal size. It can be used for fitting wrist cir­
cumferences of up to 22 cm.
4.2 Application
CAUTION
Incorrect or excessively tight application
Skin irritation due to overheating, local pressure points due to tight appli­
cation to the body
► Ensure that the product is applied properly and fits correctly.
► When in doubt, do not continue to use the product if skin irritation
occurs.
> Open all hook-and-loop closures on the support.
1) Pull the loop over the thumb (see fig. 2).
2) Place the support around the wrist (see fig. 3 and see fig. 4).
3) Fasten all hook-and-loop closures.
4.3 Cleaning
NOTICE
Use of improper cleaning agents
Damage to the product due to use of improper cleaning agents
► Only clean the product with the approved cleaning agents.
1) Fasten all hook-and-loop closures.
2) Recommendation: Use a laundry bag or net.
3) Wash the support in warm water at 40 °C (104 °F) with standard mild
detergent. Do not use fabric softener. Rinse thoroughly.
4) Allow to air dry. Do not expose to direct heat sources (e.g. sunlight,
stove or radiator).
5 Disposal
Dispose of the product in accordance with national regulations.
10