Table of Contents
Advertisement
Proper maintenance of the LPV Seed Treater is critical for peak performance, reliability
and accuracy of this system. The following is a guideline for the type of maintenance
and servicing that should be performed on this unit. Your environment and uses may
require additional maintenance and service beyond this list to assure a reliable and
safe unit. The operator of this unit has ultimate responsibility to identify areas of
concern and rectify them before they become a hazard or safety issue. There is no
substitute for a trained, alert operator.
! DANGER
! DANGER
Use an SAE multipurpose high temperature grease with extreme pressure (EP)
performance. Also acceptable is an SAE multipurpose lithium-based grease.
Use a Maintenance Checklist to keep record of all scheduled maintenance.
Use a hand-held grease gun for all greasing.
Wipe grease fitting with a clean cloth before greasing to avoid injecting dirt and grit.
Replace and repair broken fittings immediately.
If fittings will not take grease, remove and clean thoroughly.
NOTICE
Also clean lubricant passageway. Replace fitting if necessary.
Si les raccords ne prendront pas la graisse, enlever et nettoyer.
AVIS
Aussi propre passage de lubrifiant. Remplacer approprié si
nécessaire .
LPV SEED TREATER
Maintenance
Do not put this unit into operation with any questionably
maintained parts. Poor performance or a hazard may occur.
Ne pas mettre cet appareil en service avec des pièces douteuse
entretenus. La mauvaise performance ou un danger peut
survenir.
Do not use compressed air or water under pressure to clean any
of the components of the USC equipment.
Ne pas utiliser d'air comprimé ou de l'eau sous pression pour
nettoyer l'un des composants de l'équipement USC.
GREASING
Section
G
Page 43
Advertisement
Table of Contents
