USC LPV Series Operator's Manual page 27

28. Two 110V (3 Amp) plugs are located on the left side of the
Main Control Panel to allow the operator to plug in a printer
to print reports directly from the HMI screen The second
plug can be used to power a laptop computer.
29. Have a certified electrician provide power to the seed treating system. Provide
convenient shutdown switches, comply with local electrical codes and ensure
that the system is properly grounded and bonded. The USC system must be
connected to the same electrical requirements as specified in the main control
panel on the power requirement tag, or the electrical schematic shipped with the
piece of equipment. This will power the USC LPV seed treater and any attached
conveyors.
NOTICE
Flexible conduit is recommended for main power supply.
AVIS Conduit flexible est recommandé pour l'alimentation principale.
30. Provide 110V single phase power to the main control panel, I/O control panel and
the pump stand(s).
31. Reverse the previous steps when removing the machine from its working position.
LPV SEED TREATER
Page 27