Gastroback DESIGN FOOD PROCESSOR ADVANCED Operating Instructions Manual page 60

WARNING:
9. Connect the power plug to a suitable wall power outlet.
Start the appliance pressing the ›ON‹ button. The motor starts working, the food
is getting processed and gathered at the base of the bowl. While proceeding
do not push the food pusher too hard down to avoid overloading the motor. If
the motor stalls or stucks during operation or if the fibre of the food blocks the
blade, immediately turn ›OFF‹ the appliance and unplug the power cord. Check
whether there is any obstruction in the processing bowl, and remove it (see 'Care
and Cleaning‹).
ATTENTION:
minutes to avoid overheating. If processing large quantities of food, regularly interrupt
operation and unplug the appliance for at least 1 minute, to let the motor cool down.
Note:
The Food Processor is fitted with a safety thermal cut-out device and will shut off in
the event of overload. If this occurs, switch the appliance off and it will automati-
cally reset when cool.
10. You can continue to fill the feed chute as soon as the feed chute is empty.
ATTENTION:
the motor is running because little pieces of food could be thrown out of the feed
chute.
WARNING: Do not overfill the processing bowl. Possibly, take some
food out of the processing bowl, using a wooden or plastic spoon,
before starting the appliance again.
Note:
Very stringily food can block the blades. In this case turn the appliance off, wait
for the disc to stop moving and remove the plug from the power outlet. Take off
the lid by turning it counterclockwise. Remove the disc. Rinse the disc thoroughly
under running water and remove food residues. Assemble the appliance and con-
tinue to operate.
11. As soon as the food has the right consistency turn the appliance ›OFF‹. Always
turn the appliance ›OFF‹ and pull the plug when the appliance is not in use and
you finished the operation.
12. Empty the bowl. Clean the appliance in accordance to the instructions in chapter
›Care and Cleaning‹. Do not leave any food dry on the surfaces of the appli-
ance.
60
To refill the feed chute always remove the food pusher first.
Do not use the appliance in continuous operation for more than 4
Never hold your face or other body parts over the feed chute when