Adam Equipment CBD Series Service Manual page 13

Use [U.Wt/Unit] to select the decimal
point position and press [Print].
To change the remote scale cap press
CE to clear and then enter new value
followed by [Print].
Press the [U.Wt/Unit] to go to next
menu. Press [Print] to enter.
Use [U.Wt/Unit] to select the division
which you would like the display to
increment in followed by [Print].
Press the [U.Wt/Unit] to go to next
menu, use [Print] key to enter.
Use [U.Wt/Unit] to increment the
values then [Print].
Press the [U.Wt/Unit] to go to next
menu, use [Print] key to enter.
Use [U.Wt/Unit] to increment the
values then [Print].
Press the [U.Wt/Unit] to go to next
menu, use [Print] key to enter.
Use [U.Wt/Unit] to increment the
values then [Print].
Press the [U.Wt/Unit] to go to next
menu, use [Print] key to enter.
Enter the new PIN number and press
[Print].
Confirm the new PIN number and
press [Print].
Press [U.Wt./Units] to continue or
escape the parameters with the
[zero/Tare]
@Adam Equipment Company 2007
"CAp". Scale capacity setting.
"dESC" " 0.00"
"SEL" "0060"
"div" weighing division.
"inc 5"
"Azt"
Autozero tracking range.
Select from 0.5d, 1d, 2, 4,d
"0 Auto"
Zero auto range at
power on.
Select form 0%, 2%, 5%, 10% or 20%
"0 manl" Zero manual range.
Select form 0%, 2%, 4%, 10%, 50% or
100%
"Pin" Password number for "tEch".
"Pin1"
"Pin2"
"donE"
11