Storage And Disposal - Husqvarna SMART 40 Operator's Manual

Problem
The product stops during operation.
LED light status
LED status
Green light
Flashes green
Flashes red
Flashes green and red
Red light
Storage
• Clean the product before storage.
• Keep the product in a dry and frost-free area.
• Keep the product in a locked area to prevent access
for children or persons that are not approved.
Disposal of the product
• Obey the local recycling requirements and applicable
regulations.
1004 - 001 - 01.04.2020
Cause
The residual-current device found a
fault.
The product is too hot.
Overload in the product.
Product status
Connected to the power source
Work in progress. Too low current.
The frequency converter box or the
vibrator head is too hot.
Too high or too low voltage.
Overload. Short circuit between pha-
ses. Insulation fault in the vibrator
head. Problem in the frequency con-
verter.

Storage and disposal

•
Solution
Examine the cables and the frequen-
cy converter. Replace the cable or
the frequency converter.
Stop the product and move it from
sunlight.
Examine if there is a short circuit be-
tween the phases on the vibrator
head side.
Examine if there is a short circuit be-
tween the phases and ground on the
side of the vibrator head.
Procedure
N/A
Examine if the vibrator head is
blocked or overload.
Let the frequency converter and vi-
brator head cool down.
Examine the voltage of the power
source.
Examine the frequency converter and
vibrator head for damage. If it is nec-
essary, send the product to an au-
thorised service center.
When the product no longer is used, send it to the
dealer or discard it at a recycling location.
11