Husqvarna SMART 40 Operator's Manual page 9

2. Attach the screw to the hose nipple and the vibrator
head with a threadlocker. Make sure that you use
the correct threadlocker type, refer to
torque and threadlocker type on page 9 .
3. Use connectors to keep the wires together. Use
thermal insulation to connect the wires to the stator.
4. Put the wires into the red hose and put the red hose
adjacent to the gland.
5. Use a clamp to connect the hose to the hose nipple
on the vibrator head.
Lubrication
Vibrator head
3
Shell T46, cm (cl)
Tightening torque and threadlocker
type
B
A
Tightening torque, Nm
Vibrator head
End cap (A)
Screw (B)
Nipple (C)
Threadlocker type
Vibrator head
End cap (A)
Nipple (C)
1
Thrust screw (D)
Screw (E)
1
The thrust screw holds the ground cable and seals the vibrator head. If the thrust screw is not sealed correct-
ly, oil can leak from the vibrator head.
1004 - 001 - 01.04.2020
Tightening
SMART40/ 40E
5 (0.5)
B D
C
40/ 40E
170 Nm
5 Nm
120 Nm
40/ 40E
® ™
LOCTITE 638
® ™
LOCTITE 243
® ™
LOCTITE 243
® ™
LOCTITE 243
6. Move the wires into the frequency converter casing,
through the gland.
7. Tighten the nut and put the red hose on the hose
nipple on the frequency converter. Attach the red
hose with a clamp.
8. Use connectors to connect the wires in the
frequency converter.
9. Put the cover on the frequency converter.
SMART48/ 48E
10 (1)
E
48/ 48E
350 Nm
8 Nm
200 Nm
48/ 48E
® ™
LOCTITE 638
® ™
LOCTITE 243
® ™
LOCTITE 243
® ™
LOCTITE 243
SMART56/ 56E SMART65
15 (1.5) 20 (2)
56/ 56E
520 Nm
8 Nm
250 Nm
56/ 56E
® ™
LOCTITE 638
® ™
LOCTITE 243
® ™
LOCTITE 243
® ™
LOCTITE 243
65
750 Nm
20 Nm
250 Nm
65
® ™
LOCTITE 638
® ™
LOCTITE 243
® ™
LOCTITE 243
® ™
LOCTITE 243
9