Trango Systems Atlas5010 User Manual page 24

Configuration
defaultopmode [on|off]
encrypt [on|off]
encrypt key <key>
exit
freq [<ch#> <antenna>]
freq writechannel <ch#> <freq>...
freq writechannel default
help [<command>]
ipconfig [<ip> <subnet> <gateway>]
linktest <local tx rate> <peer tx rate>
[<pkt size> [<# of pkt> [<# of
cycle>]]]
mir [<kbps>]
opmode [on|off]
password <ro|rw|upgrade>
peerid [<peer device id>]
power [<dBm>]
reboot
remarks
reset
rssi
rssiled [on|off]
speed [<tx rate>]
survey [<sec>]
survey <sec> all
survey <sec> [<ch#> [..]]
sysinfo
Trango Broadband Wireless — Atlas5010
Set or display default opmode. Radio must be set to opmode ON to
establish wireless link.
Default setting=OFF
Enable or disable proprietary 128 bit tx encryption.
Default setting=OFF
Change encryption key (128 bits)
<key> = xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx
Exit telnet session
Set or display channel and antenna selection.
Modify channel table, up to 6 channels at a time.
Restore factory default channel table.
Display command usage and syntax.
Change ip configuration.
<ip> = ip address
<subnet> = subnet mask
<gateway> = gateway ip address
RF link loopback test .
This is the primary loopback test utility for evaluating over-the-air
link quality. Provides link reliability information and dropped packet
statistics. Standard linktest transmits 1600 byte packets, 1000
packets per second for 10 cycles. User can specify packet size,
quantity of packets, number of cycles
<tx rate> = 6,12,18,24,36,48,54 Mbps
Set or display tx maximum information rate (MIR). MU and RU
can be set with different mir for asymmetric upload and
download.
<kbps> = 100..50000
Set or display operation mode (on or off)
Change password.
<ro> = for read-only
<rw> = for read-write
<upgrade> = for upgrading firmware
Set or display peer device id.
Set or display tx power..
<dBm> is limited by area (ref: "sysinfo 4")
Reboot unit.
Enter user remarks up to 80 characters.
Restore all factory defaults except ipconfig and passwords.
Display RF relative signal strength indication (rssi) from peer radio.
Enable or disable rssi LED update.
Set or display tx rate
<tx rate> = 1,2,6,9,11,12,18,24,36,48,54 Mbps
Display noise floor for current channel .
<sec> = period 10..3600
Display noise floor for all available channels.
Display noise floor for selected channels.
Display all system information.
default = 10
page 24