HomeMatic HM-LC-Dim1T-FM Installation And Operating Manual page 28

not exceed 16A.
The installation of the actuator that is described is
shown in the following connection diagram.
Connect the actuator to L and N to obtain a power
supply.
Phase for pushbuttons is provided at the
pushbutton input. Route the switched phase to the
consumer.
There are no controls on the device itself. A
pushbutton must be connected (even if it is
only temporary) for direct teach-ins without the
HomeMatic central control unit.
The control input is switched with mains
voltage. Only pushbuttons and cables that
are rated for mains voltage may be used!
Only connect pushbuttons at the input,
not switches! This would make the device
malfunction!
28