Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
In order to achieve a correct installation of this device, follow these steps:
1.
Choose the right location to install the Ecombi HHR. The minimum clearances must be respected from the
appliance to any combustible material such as furniture or curtains. To reduce the risk of fire, do not store
or use petals or other flammable liquids and vapours in the vicinity of the heater.
2.
Open the heater box at the indicated side and install the supporting feet without removing the heater.
3.
Flip the box upside down to allow the heater
to stand on its feet and remove the carton.
Please check that it is the correct model and
is in good condition.
Check that all parts have been delivered and are
intact:
-
1 ECOMBIHHR heater casing.
-
1 Bag containing 2 screws, 2 rawl plugs,
4 white screws and 2 black female spade
connector wires.
-
2 supporting feet.
-
1 top fixing plate.
-
2 side fixing plates.
-
This Guide
Elnur powered by Gabarrón | ECOMBI HHR | Installation Guide
The casing and storage bricks are supplied
!
separately. Check the supplied brick
packages correspond to the ones indicated
on the heater carton.
The heater operation is not affected if bricks
!
with minor damage are used.
4.
Screw the top fixing plate to the wall, making the
two required points to drill at the recommended
distance depending on the model. Use the rawl
plugs and screws contained in the plastic bag
to fix the fitting to the wall.
4
Hide quick links:
Advertisement
Table of Contents
