Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
5.
Fix the side fixing plates to the metal casing by using the appropriate screws. The supply cables must be
fitted but not wired to the storage heater before placing the heater to the wall. Remove the white screws
located in the top of ECOHHR, and place the ECOHHR in the selected installation area. Use the removed
screws to attach ECOHHR to the top fixing plate installed in the wall.
6.
Take off the front outlet grill by removing the four screws. Take off the front panel by removing the two
screws located at the bottom.
7.
Connect the heater using the wiring diagram included at the end of the installation instructions. Tighten the
connection block screws securely. Do not leave any remaining wire inside the heater.
The heater is ready to be wired to a double power supply (Economy and 24hr supply). If the heater is to be wired
to a single economy/24 hours power supply:
-
Use the 2 black wires provided in the plastic bag to jumper the Lines and Neutrals of the Restricted
and Unrestricted side.
-
Connect the supply to the restricted or unrestricted side.
WARNING: Touching live connections can cause death from electric shock.
!
Elnur powered by Gabarrón | ECOMBI HHR | Installation Guide
ECOHHR MUST NOT BE HUNG ON THE SCREWS; these are
used only to prevent the device from overturning and
not to support it. If there is any doubt concerning the
wall strength, consult the corresponding construction
specialist. The appliances are heavy; it is the installers
responsibility to ensure the correct installation and
wall support of these devices to prevent them from
overturning.
5
Hide quick links:
Advertisement
Table of Contents
