Table of Contents
Advertisement
6 Operation
•
The corresponding parameter value is displayed for approxi-
mately 15 seconds by pressing
15 seconds, the instrument returns to run mode.
Programming mode
Setting the parameter values
The instrument is switched to programming mode if a parameter is
selected and the
(the parameter value flashes, then is continuously increased).
Internally, the instrument also remains operational here.
It continues to carry out its monitoring functions with the existing
parameters until the alteration is completed.
You can change the parameter value using
pressing [Mode/Enter].
The instrument returns to measurement mode if no buttons are
pressed for 15 seconds afterwards.
6.1.2.
Programming
4
Lowering the value: Allow the display to run through to the maximum setting
value. After this, the run-through starts again from the minimum setting value.
30
[Set]
button is pressed for longer than 5 seconds
[Set]
briefly. After a further
[Set]
and confirm by
Press
[Mode/Enter]
the desired parameter
appears in the display.
Press and hold [Set].
The current parameter
value flashes for 5 sec-
onds.
It is then increased
steps by pressing once or
continuously by pressing
and holding the button).
Press
[Mode/Enter]
briefly (confirmation). The
parameter is displayed
again and the new pa-
rameter value applies.
until
4
(in
Advertisement
Table of Contents
