Table of Contents
Advertisement
5 Initial operation
Installation
The pipe must be completely free of any dirt, rust or grease at the
assembly point of the clamp. Cleaning with soapy water is best for
this, as it also improves the functionality of the clamp.
Seals, nuts and bolts must not be greased!
Remove the caps on the threaded bolts and unscrew the nuts up to
the end of the threaded bolt (do not remove them).
Unfold the pipe clamp and place the upper clamp part around the
pipe.
Hang the retaining bracket correctly over the screw yoke on one
side.
Feed the loose bottom clamp part underneath the pipe and hang it
loosely on the other screw yoke using the free retaining bracket.
When doing this, ensure that both holder lips are inserted smoothly
under the seals.
The clamp must no longer be moved radially from this position.
Check that the seals and holder lips are positioned on the pipe and
that the sharp ends are positioned smoothly over the seals. Tighten
the nuts by hand on the retaining bracket attached loosely to the
screw yoke until the bracket is under tension.
19
Advertisement
Table of Contents
