Landscape Forms Torres Installation Manual

Torres
Catenary light
Installation Guide
Included components
1X – threaded
plug
1X – luminaire
assembly
4X – M6 x 1
Nylon locknut
4X – M6 x 1 x 35mm
Socket hd
Cap screw
Tools Required
• Safety glasses
• 10mm wrench
• 13mm socket and ratchet wrench
• 13mm box wrench
• 32mm wrench
• 25mm wrench
• 3mm hex key
• 4mm hex key
• 5mm hex key
• Wiring tools and connectors
• Pliers
• Flat blade screwdriver
• Hanging cable, min dia. 0.25", max dia. 0.50"
ASSEMBLE WITH CARE! Pangard II Polyester Powdercoat is a strong, long‐lasting finish. To
protect this finish during assembly, place unwrapped powdercoated parts on packaging foam or
other non‐marring surface. Do not place or slide powdercoated parts on concrete or other hard or
textured surface – this will damage the finish causing rust to occur. Use touch‐up paint on any
gouges in the finish caused by assembly tools.
2X – M8 x 1.25
2X – M8 x 1.25 x
Nylon locknut
40mm
Hex head screw
2X – tabbed
2X – cable blocks
washer
WARNING! Installer must provide strain relief to line‐in wires where they connect to light
fixture wires. Failure to do so may cause electrical failure and will void warranty.
Landscape Forms is not responsible for site preparation.
4X – M8
INSTALLATION PROCEDURE:
washer
Note: The catenary luminaire ships assembled. Supporting cable and line‐voltage
supply wires are not included. Cable clamp is designed for Ø1/4"‐Ø1/2" cables.
Cable glands accept supply wires between Ø0.24" – Ø0.47".
1. Set luminaire on supporting cable. See Fig. 1.
2. Install cable blocks, using M6 x 35mm socket head cap screws, tabbed washers
and locknuts as shown in Fig. 1. Tighten securely. Once tightened, bend tabs
down on washers to ensure locknuts cannot loosen.
2X – M6 x 8mm
3. Install M8 x 40mm hex head screw, washers and locknuts to lock vertical rotation,
Hex head
Set screw see Fig. 2.
4. Remove connection box cover. Retain screws. See Fig. 3. Leave lanyard and
screws attached to prevent cover from falling.
5. Orient luminaire in the desired position. Tighten large nut inside connection box
to lock horizontal rotation. Install set screws on stem and tighten, see Fig. 4.
6. Run electrical supply cable (not included) to wiring connection box and make
wiring connections, see Fig. 5.
7. If only one side of the connection box is needed for line‐in wires, remove the
unused cable gland and replace with the threaded plug. Tighten securely with a
wrench, see Fig. 6.
8. Replace connection box cover.
Date: June 6, 2019
www.landscapeforms.com Ph: 800.521.2546
Page 1 of 4