Landscape Forms Ashbery Installation Manual

Ashbery
Path Light
Installation Guide
Surface Mount
Included items:
2x – M8 x
25mm hex
head cap
screw
1x – Light
Hardware ships installed on unit
assembly
Tools Required
• Safety glasses
• Wiring tools and connectors
• Anchoring hardware – (4) Ø5/16 [8mm] (maximum), with bolt head and washer not
to exceed dimensions in Fig. 3. Maximum washer O.D. is 0.734".
• Hammer drill
• 13mm ratchet wrench
• 2.5mm hex key
LIGHTING LAYOUT RECOMMENDATIONS:
Refer to the Product Data Sheet
ASSEMBLE WITH CARE! Pangard II Polyester Powdercoat is a strong, long-lasting finish. To protect
this finish during assembly, place unwrapped powdercoated parts on packaging foam or other non-
marring surface. Do not place or slide powdercoated parts on concrete or other hard or textured
surface – this will damage the finish causing rust to occur. Use touch-up paint on any gouges in the
finish caused by assembly tools.
1x – anchor
2x – M8
2x – M4 x
template
washer
14mm
button head
cap screw
Fig. 1 – Minimum footing recommendation
FRAME
CASTING
BASE
CASTING
Fig. 3 – Base plate section view
Date: March 19, 2021
www.landscapeforms.com Ph: 800.521.2546
SIDEWALK
Fig. 2 – Recommended setback
from sidewalk
Fig. 4 – conduit clearance
Page 1 of 2