Landscape Forms Typology Installation Manual

Typology
Path Light
Installation Guide
Single Double
Included components
1x – unit
1x – unit
1x – concrete
body
body
panel single
single
double
Tools Required
• Safety glasses
• Screwdrivers
• Wiring tools and connectors
• Masonry drill, with Ø1/2" bit
• Compressed air and wire brush
• Epoxy anchoring system for concrete
• 1/2" socket wrench
• 5/32" hex key
LIGHTING LAYOUT RECOMMENDATIONS:
Refer to the Typology Path Light product data sheet at
more information.
ASSEMBLE WITH CARE! Pangard II Polyester Powdercoat is a strong, long-lasting finish. To
protect this finish during assembly, place unwrapped powdercoated parts on packaging foam or
other non-marring surface. Do not place or slide powdercoated parts on concrete or other hard or
textured surface – this will damage the finish causing rust to occur. Use touch-up paint on any
gouges in the finish caused by assembly tools.
Included hardware
4x – 5/16-
18 x 1" HEX
BOLT
4x – 5/16-
1x –
4x – 11/16
18 concrete
anchor
OD washer
anchor
template
2x – concrete
1x – concrete
panel double
panel single
www.landscapeforms.com
Landscape Forms is not responsible for site preparation and footings. Footing
recommendations are included in these instructions.
Fig. 1 – Minimum footing recommendation
for
EDGE OR
EXPANSION
JOINT
Fig. 2 – Minimum concrete slab size
Date: March 21, 2022
www.landscapeforms.com
TEMPLATE
Fig. 3 – Assemble anchor template
FRONT OF
LIGHT
Fig. 4 – Proper orientation
of conduit
HEX BOLT AND
WASHER
CONCRETE
ANCHOR
SIDEWALK
Fig. 5 – Recommended
setback from sidewalk
Ph: 800.521.2546
HEX BOLT
WASHER
CONCRETE
ANCHOR
CONDUIT
Page 1 of 3