Replacing The Serial/Parallel Cable Assembly; Figure 6-4 Removing And Replacing The Serial/Parallel Cable Assembly - Sun Microsystems Sun Ultra 5 Service Manual

Serial/parallel
cable assembly
FIGURE 6-4
6.2.6

Replacing the Serial/Parallel Cable Assembly

1. Replace the serial/parallel cable assembly as follows (
a. Position the serial/parallel cable assembly into the chassis.
b. Position the serial/parallel cable connector-assembly into the chassis opening.
Using a No. 2 Phillips screwdriver, replace the screw securing the connector
assembly to the chassis.
c. Connect the serial/parallel cable assembly connector to the motherboard (J7/J8).
Note – Verify that the cable connectors are oriented properly by aligning the
connector keys.
2. Detach the wrist strap, replace the system cover, and power on the system as
decribed in Chapter 10.
6-8 Sun Ultra 5 Service Manual • February 2000
Removing and Replacing the Serial/Parallel Cable Assembly
Screw
):
FIGURE 6-4