Sun Microsystems Sun Ultra 5 Service Manual page 81

the watch-net-all command at the ok prompt. The following code example
identifies the watch-net diagnostic output message.
watch-net-all diagnostic output message.
Watch-Net Diagnostic Output Message
CODE EXAMPLE 4-2
ok watch-net
Hme register test --- succeeded.
Internal loopback test -- succeeded.
Transceiver check
passed
Using Onboard Transceiver - Link Up.
Looking for Ethernet Packets.
'.' is a Good Packet.
Type any key to stop.
..................................................
................................................................
................................................................
........................................................
ok
Watch-Net-All Diagnostic Output Message
CODE EXAMPLE 4-3
ok watch-net-all
/pci@1f,0/pci@1,1/network@1,1
Hme register test --- succeeded.
Internal loopback test -- succeeded.
Transceiver check
passed
Using Onboard Transceiver - Link Up.
Looking for Ethernet Packets.
'.' is a Good Packet.
Type any key to stop.
........
................................................................
................................................................
................................................................
....................................
ok
-- Using Onboard Transceiver - Link Up.
'X' is a Bad Packet.
-- Using Onboard Transceiver - Link Up.
'X' is a Bad Packet.
Chapter 4
identifies the
CODE EXAMPLE 4-3
Troubleshooting Procedures 4-9