Avaya Scopia XT Series Release Notes page 37

© 2017 Avaya Inc. All rights reserved
Release Notes for Avaya Scopia® XT Series
Flex camera can be cascaded
only as last camera in the chain.
Some older Flex camera models
do not support cascading.
Please check that the Flex
Flex Camera for camera (Model VC-B20DRV)
cascading serial number (available in a
label on the bottom of the
camera as aside) is higher than
V13C04411 or is in the format
V13xxyyzzzz (without any
letter).
The USB camera is not detected
The Audio Input HD could not
QC#19134 work properly if its field 'Echo
canceller' was set to 'Yes'.
When restoring the system to
factory default settings, the
QC#16369
screen may appear black for a
long time.
Cancelling the screen saver
QC#16506 while it is activating can cause
the camera to move.
SI #161991: [Executive]
Sometimes the XT Control
application could not realize the
QC#20697
changes applied into the
Windows OS Screen Resolution
menu.
Analog/Digital DVI PC resolution
1280x960 could be treated as
720p or 1080p
(encoding/detected format).
SI #161841: [Executive] XTE240
local PC video could flash when
the PC user moves between
QC#20566 different PC active applications
and the XTE is configured to be
the 'Extended'/Second Monitor
of the PC.
Audio transmission/reception
could be choppy when using
RVXT5000-615
USB headset connected to
upper USB port.
Sometimes the system is turned
on but the camera image is not
QC#25198 present. This is more frequent
using the XT camera switch, for
the first camera.
select manually the proper Driver for each camera
input, in the order in which they will be cascaded.
Disable all the intermediate inputs that will not be
cascaded.
Power off the system.
Insert the three connectors of the special cable for
the first camera to the sockets on the back of the
first camera; pay attention to insert the 8-pin
connector to the IN RS232C socket of the main
camera.
Connect a crossed VISCA cable from the OUT
RS232C connector of the first camera to the IN
RS232C connector of the second camera.
Repeat with additional crossed VISCA cables if you
have a third camera for XT7000 or more cameras
when using an XT camera switch.
Connect each additional camera to its power source
and to XT HD or DVI input, or to the proper HD slot
of the XT Camera Switch.
Power on the system.
USB cameras must be plugged in the upper USB slot
available in the XT rear panel.
Close the XT Control application before any changes
are going to be applied into the Windows OS menu
Control Panel > Display > Screen Resolution.
This issue belongs to the Windows ('Aero') preview
feature when selecting/moving between
different/open PC application windows and could
appear with any third party 'Extended'/Second PC
Monitor.
Connect USB headset to lower USB port.
Unplug and then pug again the Camera power
connector or use a Flex/Deluxe camera.
Known Issues | 37