Installing The Software; Note About Matrox Intellicam - Matrox Meteor-II /Digital Installation And Hardware Reference

Table of Contents

Chapter 3: Installing software

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Installing the software

To install any Matrox Imaging software, place its CD in the

appropriate drive; the setup.exe file will run automatically.

While installing the software, you will be asked to provide the

following information:

The drive and directory in which to install the software.

■

The target operating system and compiler.

■

The type of Matrox hardware that is installed in your

■

computer.

❖

If you have an MGA graphics board, you should install the

display driver that is on the CD.

After installation, read the readme file(s) recommended by the

installation program.

MIL-Lite uses digitizer configuration formats (DCFs) to

configure the camera interface on Matrox digitizers. The DCF

defines, among other things, the video timing signals and the

video data format. Matrox Intellicam can be used to create or

customize a DCF file, if the supplied files do not include one

that matches your video source.

For more information about Matrox Intellicam, refer to the

Matrox Intellicam User Guide.

Table of Contents