Matrox Meteor-II /Digital Installation And Hardware Reference page 23

22 Chapter 2: Hardware installation
PC/104-
expansion site
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
J3
Remove pin D30
30
in a 3.3 V system
Plus
PC/104-
PCI
connector
1
Plus
D C B A
Remove pin A1
in a 5 V system
2. Check that you have an available PC/104-Plus connector on
the motherboard, or verify that your existing stack can
support another board.
3. Remove the anchoring screws from the stack; do not discard
them since you will need them to fasten the Matrox
Meteor-II board.
4. If you have existing PC/104 boards in your computer,
remove them and stack them on the PC/104-Plus board.
PC/104 boards must be stacked last.
5. Carefully position Matrox Meteor-II over the connectors
and press the board firmly into place.
6. Replace the anchoring screws.
7. Assemble a cable using two ribbon cables of the appropriate
length, the two included video input low profile IDC
connectors, and two connectors capable of interfacing with
the connectors of your camera's cable. See Appendix B for
the pinouts, signals, and ribbon cable information. A
standard cable for PC/104-Plus form factor boards is not
available from Matrox.
8. Attach the newly assembled cable to the video input
interface connectors.
J1
32
J2
19
Plus
PC/104-
ISA
connectors
0
C D
1
B A
Top view