Exchange Of Presser Foot - SunStar SC 7900-Series User Manual

Direct drive, 4-needle flat seamer feed off the arm type

Hide thumbs Also See for SC 7900-Series:

Table of Contents

9) EXCHANGE OF PRESSER FOOT

Check the OFF-status condition of a power switch before exchanging the presser foot.

Warning

① Remove the needle in the needle holder.

② Remove the rubber capⓐ. (Refer to the Figure 63)

③ Loosen the presser bar adjusting screwⓑ and the presser bar

connection bracket clamp screwⓒ (Refer to the Figure 63)

④ Loosen the knife holder guide clamp screwⓓ. (Refer to the

Figure 64)

⑤ Loosen the knife holder shaft support bar clamp screwⓔ and

remove the knife holder shaft support bar A.

(Refer to the Figure 65)

ⓑ

ⓐ

ⓝ

ⓒ

ⓚ

[ Figure 63 ]

ⓓ

[ Figure 64 ]

ⓗ

ⓕ

ⓔ

[ Figure 65 ]

Table of Contents

Sc 7900-02 m6 a